Committee:
ISO/TC 45 Rubber and rubber products
CEN/TC 208 Elastomeric seals for joints in pipework and pipelines
CEN/TC 218 Rubber and plastics hoses and hose assemblies
* Some activities of this TC correspond to other AEN/CTN.
Standards developed by the committee: CTN 53/SC 1: 484
Status: VIGENTE / 2020-01-01
Elastomers. Rubber products in automotive applications. Characteristics and designation.
Elastomers. Specification and test methods for elastomer seals used in lighting. Characteristics and test methods.
Elastomers. Methods of testing rubber O-Rings
Status: VIGENTE / 2019-10-16
Rubber hoses and hose assemblies for liquefied petroleum gas, LPG (liquid or gaseous phase), and natural gas up to 25 bar (2,5 MPa) - Specification
Status: VIGENTE / 2019-07-10
Clamp type coupling assemblies for use with steam hoses rated for pressures up to 18 bar
Rubber, vulcanize or thermoplastic. Determination of stress relaxation in compression. Part 1: Testing at constant temperature
Status: VIGENTE / 2019-06-19
Rubber, raw — Determination of volatile-matter content — Part 1: Hot-mill method and oven method
Rubber, vulcanized or thermoplastic -- Determination of low temperature stiffening (Gehman test)
Rubber. Determination of crystallization effects by hardness measurements.
Status: VIGENTE / 2019-06-05
Rubber hoses and hose assemblies - Rubber-covered spiral wire reinforced hydraulic type - Specification
Rubber or plastics hoses and hose assemblies - Hydraulic impulse test with flexing (ISO 6802:2018)
Status: VIGENTE / 2019-02-13
Rubber, vulcanised or thermoplastic. Determination of tension set under constant elongation, and of tension set, elongation and creep under constant tensile load
Status: VIGENTE / 2018-06-06
Rubber. Determination of solvent extract
Status: VIGENTE / 2018-05-30
Rubber, vulcanized or thermoplastic. Determination of permeability to gases. Part 1. Differential pressure methods.
Status: VIGENTE / 2018-05-10
Rubber and plastics test equipment. Tensile, flexural and compression types (constant rate of traverse). Specification.
Conducting and dissipative rubbers, vulcanised or thermoplastic. Measurement of resistivity
Status: VIGENTE / 2018-04-25
Rubber hoses and hose assemblies, wire or textile reinforced, for dredging applications - Specification (ISO 28017:2018)
Rubber and plastics hoses and tubing - Measurement of flexibility and stiffness - Part 1: Bending tests at ambient temperature (ISO 10619-1:2017)
Status: VIGENTE / 2018-04-11
Rubber and plastics hoses - Assessment of ozone resistance under dynamic conditions (ISO 10960:2017)
Rubber hoses and hose assemblies for aircraft ground fuelling and defuelling - Specification (ISO 1825:2017)
Back to results New Search
Design your own personalised collection of standards. Keep your standards updated.
