Committee:
GT 1 Bituminous mixtures
GT 2 Surface dressing and slurry surfacing
GT 3 Materials for concrete roads including joint fillers and sealants
GT 4 Hydraulic bound and unbound mixtures
GT 5 Características superficiales
ISO/TC 43/SC 1 Noise
CEN/TC 227 Road materials
* Some activities of this TC correspond to other AEN/CTN.
Standards developed by the committee: CTN 41/SC 2: 336
Status: VIGENTE / 2024-09-11
Primers for cold and hot applied joint sealants - Part 1: Determination of homogeneity
Primers for cold and hot applied joint sealants - Part 2: Determination of resistance against alkali
Primers for cold and hot applied joint sealants - Part 3: Determination of solids content and evaporation behaviour of volatiles
Hot applied joint sealants - Part 5: Test method for the determination of flow resistance
Status: VIGENTE / 2024-07-29
Slurry surfacing - Test methods - Part 1: Sampling of slurry surfacing mixture
Slurry surfacing - Test methods - Part 2: Determination of residual binder content including preparation of samples
Slurry surfacing - Test methods - Part 3: Consistency
Slurry surfacing - Test methods - Part 4: Determination of cohesion of the mix
Slurry surfacing - Test method - Part 5: Determination of the minimum binder content and wearing resistance
Slurry surfacing - Test methods - Part 6: Rate of application
Bituminous mixtures - Test methods for hot mix asphalt - Part 38: Common equipment and calibration
Status: VIGENTE / 2024-07-26
Unbound mixtures - Specifications
Unbound and hydraulically bound mixtures - Part 1: Test methods for laboratory reference density and water content - Introduction, general requirements and sampling
Unbound and hydraulically bound mixtures - Part 3: Test methods for laboratory reference density and water content - Vibrocompression with controlled parameters
Unbound and hydraulically bound mixtures - Part 4: Test methods for laboratory reference density and water content - Vibrating hammer
Unbound and hydraulically bound mixtures - Part 40: Test method for the determination of the direct tensile strength of hydraulically bound mixtures
Unbound and hydraulically bound mixtures - Part 42: Test method for the determination of the indirect tensile strength of hydraulically bound mixtures
Unbound and hydraulically bound mixtures - Part 43: Test method for the determination of the modulus of elasticity of hydraulically bound mixtures
Unbound and hydraulically bound mixtures - Part 46: Test method for the determination of the moisture condition value
Unbound and hydraulically bound mixtures - Part 5: Test methods for laboratory reference density and water content - Vibrating table
Back to results New Search
Design your own personalised collection of standards. Keep your standards updated.
